Am I doing something wrong or should I keep running different test. Other than that here are my 2nd and 3rd attempt with the test. Just needed to edit power and speeds in text settings on the test generator. Well I found why my text was not showing up. For some reason the writing of the power and percentage did not etch but the little squares did? Please reply with any feedback ? I want to engrave a piece I sort of design into a stove top board or noodle board for my daughter but maybe get this generator working right first. I started out to slow I believe so I stop and edit the generator, but not sure where to go next. I hope to post it in the new project files. Although my intentions were not to burn but try to find the best settings for that material that I want to burn a design or engrave into soon. I was pretty surprise on how deep my 5.5 watt would burn into my test piece which was a piece of 3/4 pine board. My first time at trying to use the generator in my Laser tools category.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |